INSTALLATIONQuick and Easy Installation INTELLI-Flush™ is ready to install on the following series*: |
||
|
 |
|
| COMPONENTS Tools Required: Phillips and slotted screwdrivers, pliers, and ruler |
||
|
A) Flush Module |
 |
|
| The Sensor and Flush Module contained within this kit have been programmed to work together and should not be switched with similar components from other kits. | ||
| STEP #1 | ||
| 1) Remove retainer clips, (image 1), flush rod, (image 2), and handle, (image 3). (Note: reverse threads on handle.) | ||
  
|
||
| STEP #2 | ||
| 1) Install override Button (D), (image 4). Identify appropriate Adapter (L or M) if needed, (image 5). | ||
 |
||
| 2) Place Flush Module (A) in position over Actuator (image 6). (Actuator is the centered white disk with Phillips screw in center.) If using Adapter, (image 7) note the positioning of the Flush Module (A) wire, (image 6 & 7). | ||
 |
||
| 3) Insert T-wrench/Depth Gauge/Sensor tool (F) in hole of Flush Module (A), (image 8). Adjust Actuator by loosening set screw and turning Actuator to proper height according to depth gauge, so that yellow ring on depth gauge aligns with top of Flush Module (A), (image 9). Tighten set screw on Actuator. | ||
 |
||
| STEP #3 | ||
| 1) Plug override Button (D) wire into Flush Module (A), (image 11) | ||
 |
||
| 2) Remove cover on Battery Pack (B), (image 12). Install batteries, (image 13), noting the battery polarity (+/-) printed on pack. Reinstall cover on Battery Pack (B), (image 14). Place Battery Pack (B) in Battery Holder (C), (image 15). Hang Battery Holder (C) on top edge of china tank and connect the Flush Module (A) wire into the Battery Pack (B). Slide rubber boot over connection, (image 16). (Using the Battery Holder (C) is optional. If there is ample space, you can place it anywhere in the tank as long as the wire is not being stretched.) | ||
 |
||
| NEXT >> | ||
