Download the Pocket Guide
A complete resource for Flushmate equipped toilets, replacement systems, parts, tools, and accessories.
Download Pocket GuideResources
Find guides, spec sheets, how-to videos and more for your Flushmate system.
Customer Support
+1 (800) 533-3460Monday-Friday 9 am - 5 pm EST
Flushmate Offices
30075 Research Drive
New Hudson, MI 48165
Prefer to email?
Ask a question about your flushmate system or request product literature.
Go to contact formFind resources by Flushmate model
The knowledge center for Flushmate products, find answers here for all your Flushmate system questions.
-
Flushmate III
503 Series
-
Flushmate III
503H Series
-
Flushmate IV
504 Series
Related Case Studies
Press Releases
Press Pickups
Frequently asked questions.
No! FLUSHMATE cannot be retrofitted to an existing gravity bowl. Bowls designed to work with FLUSHMATE harness the energy FLUSHMATE delivers to the bowl to create a "pushing" action for the waste. A gravity bowl with FLUSHMATE inside will splash excessively.
When FLUSHMATE is empty of water, it contains air at atmospheric pressure. As water from the supply fills FLUSHMATE, the air becomes trapped and is compressed. As air pressure builds to equal line pressure, water flow stops. The FLUSHMATE is ready to flush.
It's compressed air inside FLUSHMATE that increases potential energy of the entire system. The 1.6 gpf (6.0 Lpf), 1.28 gpf (4.8 Lpf) or 1.0 gpf (3.8 Lpf) of water that flows into FLUSHMATE becomes "turbocharged" by the air, giving the water flushing performance equal to 5-1/2 gallons or more.
When the toilet is flushed, this energy pushes the water into a specially designed toilet bowl. A toilet equipped with FLUSHMATE must be specifically designed to accommodate the effectiveness of FLUSHMATE. FLUSHMATE is NOT a retrofit product.
Pressure. Gravity-fed toilets are designed to siphon the waste out of the bowl, while FLUSHMATE-equipped units are designed to push the contents. There is more water behind the waste during the FLUSHMATE operation, assuring extraction and superior drainline carry. Also, FLUSHMATE-equipped bowls utilize a larger diameter and fewer bends in the trapway design. This eliminates the likelihood of double flushing and stoppages.
The FLUSHMATE 1.0 gpf (3.8 Lpf) requires line pressure of 35 psi or greater, and the 1.6 gpf (6.0 Lpf) and 1.28 gpf (4.8 Lpf) models require line pressure of 20 psi or greater.
While there are no preventative maintenance requirements, there are some very simple troubleshooting techniques outlined in the Owner's Operation and Installation Guide that any homeowner can do that cover the most common problems.
No, any required repairs can be done with the following hand tools: slotted and Phillips screwdrivers, a pair of long handled pliers, and a large paper clip.
FLUSHMATE units can emit a few drops of water inside the tank during the flushing cycle. This water collects on the bottom of the china until the water level reaches the height of the built-in drain. Normal level of water is about 1-inch.
Technical assistance is available through the FLUSHMATE Consumer Service Center in New Hudson, Michigan, by calling 800-533-3460, or 248-446-5300, or by faxing 248-446-2150, as well as through our website: www.flushmate.com. They are your sources for troubleshooting, identifying components and finding a local source for repair parts.
Click here to see warranty policy.